Quick Answer
P005E is a generic OBD-II powertrain code indicating that the engine control module (ECM) has detected a low voltage condition in the Turbocharger/Supercharger Boost Control “B” supply voltage circuit. This is a generic definition applicable across vehicle manufacturers; the specific component, wiring, and diagnostic procedures vary by manufacturer, model, and model year.
Code Definition
According to OBD-II standards, P005E is defined as:
Turbocharger/Supercharger Boost Control “B” Supply Voltage Circuit Low
Definition Scope: Generic. This code definition does not establish vehicle-specific causes, component locations, or diagnostic procedures. Manufacturer-specific implementations and testing requirements must be obtained from the applicable vehicle service manual.
What This Code Means
The ECM monitors the supply voltage to the turbocharger or supercharger boost control solenoid or actuator designated as “B.” When the monitored voltage falls below the manufacturer’s specified threshold, the code is set. The “B” designation typically indicates a secondary boost control circuit, distinct from a primary “A” circuit.
A low supply voltage condition may result from electrical faults in the supply circuit, including wiring damage, connector corrosion, or power distribution issues upstream of the component.
Diagnostic Scope
Because P005E is a generic code with a generic definition, the following are not established by this code alone:
- Which specific component (solenoid, actuator, or control valve) is affected
- The exact voltage threshold that triggered the fault
- The location of the boost control circuit wiring
- The correct diagnostic or repair procedure
- Whether a component has failed or requires replacement
Next Steps
Diagnosis of P005E requires:
- Consult the vehicle’s service manual for the specific model year and manufacturer to identify the boost control “B” circuit components, wiring diagram, and voltage specifications.
- Obtain manufacturer-specific diagnostic procedures from the service manual, including key-on and engine-running voltage tests at the appropriate connectors and test points.
- Do not assume component failure based on this code alone; electrical faults in the supply circuit (wiring, connectors, relays, or fuses) must be ruled out first.
Source
Code definition verified at: obd-codes.com (2026-11-15)
Frequently Asked Questions
Is P005E the same on all vehicles?
No. P005E is a generic OBD-II code with a standardized definition, but the specific components, wiring, voltage thresholds, and diagnostic procedures vary by manufacturer, model, and model year. Always consult the vehicle's service manual for manufacturer-specific information.
Does P005E mean the turbocharger is failing?
Not necessarily. P005E indicates a low voltage condition in the boost control supply circuit, which may be caused by wiring faults, connector corrosion, relay issues, or power distribution problems—not necessarily turbocharger failure. Diagnosis must follow the manufacturer's service manual procedures.
What is the difference between Boost Control A and B?
The 'B' designation indicates a secondary or alternate boost control circuit, distinct from a primary 'A' circuit. The specific function and component assignment depend on the manufacturer's system design and must be verified in the service manual.
Can I drive with P005E set?
That depends on the vehicle's failsafe strategy and the severity of the voltage fault. Some vehicles may enter limp mode or reduce boost pressure. Consult the service manual and have the code diagnosed promptly to avoid potential engine damage or performance loss.
Definition scope: generic