P0068: MAP/MAF – Throttle Position Correlation
Code Definition
P0068 is defined as “MAP/MAF – Throttle Position Correlation” according to generic OBD-II standards. The code signals that the powertrain control module has identified an inconsistency between the expected relationship of air intake measurement (via MAP or MAF sensor) and the driver’s throttle input (via throttle position sensor).
Definition Scope: This is a generic code definition. Manufacturer-specific implementations, threshold values, and diagnostic procedures may differ significantly across vehicle makes, models, and model years. Always consult the vehicle’s service manual for exact diagnostic criteria and repair procedures.
What This Code Means
The engine control module continuously monitors the correlation between throttle position and air intake to ensure proper engine operation. When these sensor inputs do not correlate as expected, the module sets P0068. This may indicate:
- A sensor reading that does not match the expected relationship between throttle opening and air intake
- Potential issues with sensor signal integrity, wiring, or connector conditions
- Possible control module logic faults
The presence of this code alone does not confirm a specific component failure or mandate replacement of any part.
Diagnosis and Next Steps
Proper diagnosis of P0068 requires:
- Access to the vehicle’s manufacturer service manual for the specific make, model, and model year
- Manufacturer-specific diagnostic procedures and threshold specifications
- Appropriate diagnostic equipment capable of reading live sensor data and freeze frame information
Do not attempt wiring tests, voltage measurements, or key-on/engine-running diagnostic procedures without consulting the applicable service manual, as testing conditions and acceptance criteria are manufacturer-defined.
Source
Code definition verified from obd-codes.com.
Frequently Asked Questions
Is P0068 the same on all vehicles?
P0068 is a generic OBD-II code with a standard definition (MAP/MAF – Throttle Position Correlation), but manufacturer-specific diagnostic criteria, sensor thresholds, and repair procedures vary by make, model, and year. Always refer to the vehicle's service manual for exact diagnostic steps.
Does P0068 mean a sensor has failed?
No. P0068 indicates a correlation fault detected by the engine control module. The code alone does not confirm which component has failed or that any component requires replacement. Proper diagnosis using manufacturer procedures is necessary.
Can I drive with P0068 active?
The severity and drivability impact of P0068 vary depending on the vehicle and underlying cause. Consult the vehicle's service manual or a qualified technician for guidance on safe operation and whether immediate repair is required.
What should I do if P0068 appears?
Retrieve the freeze frame data and any additional diagnostic trouble codes using a scan tool. Consult the vehicle's manufacturer service manual for the specific diagnostic procedure and testing requirements for your make, model, and year.
Definition scope: generic